3.2 Windows 95 using the Network Wizard from within SETUP
------------------------------------------------------------
When Setup starts the "Network" wizard, use these 5 easy steps to
configure TCP/IP to use the IBM 5250 Express Adapter.  If the message
"Your network setup is not complete.  Do you wish to continue?", select "Yes".

Step #1: Scroll through the list of installed network components for an entry
-------- similar to the following:

         TCP/IP -> IBM 5250 xxx Express Adapter

         * xxx can be either PCI, PC Card, or ISA (PnP)

         If an Express Adapter is one of the components installed
         choose "Add" and proceed to Step 2.

Step #2: When the "Select Network Component Type" dialog box appears, select
-------- "Protocol" and click on the "Add..." button.

Step #3: When the "Select Network Protocol" dialog box appears, select
-------- Microsoft from the list of "Manufacturers", then select TCP/IP from the
         list of "Protocols".  Click on the "OK" button.

         NOTE: Use default DHCP configuration for this protocol. Refer
               to the System Administrator, if STATIC IP addresses are desired.

Step #4: Verify that a line similar to that described in Step #1 is now
-------- present for TCP/IP in the list of installed network components.

       Note:
       Network Configuration is complete, now Select "OK" button.
       During this time Windows may prompt for Operating System
       diskettes, please have Windows 95 diskettes available.

       -----------  -----------  -----------
       | WARNING |  | WARNING |  | WARNING |
       -----------  -----------  -----------
       Windows will pop-up a "System Settings Change" Dialog Box and ask
       the User to RESTART the computer.  DO NOT CLICK on "YES"!!
       Click on the "NO" Button!!!!  This will allow the SETUP
       program to complete the installation program.



Step #5: Follow the SETUP program prompts to completion.  On completion,
-------- remove disk, then SHUTDOWN/RESTART the computer.  A successful
         driver installation will have the computer BEEP 3 TIMES.
         This indicates that a TCP/IP communications has been established with
         the AS/400 Host.  If there are any problems refer to the
         "User Guide" in IBM 5250 Express TCP/IP program group.



